Replace dirt cup as described in Fig 4.5. Allow 24 hours for filter to dry completely.Ĥ.8 Replace dirt cup lid and twist clockwise until locked in position. Rinse with water for two minutes or until water runs clear. 4.3.Ĥ.6 Twist the dirt cup handle counterclockwise to open and remove lid. To maintain optimal performance, filters should be cleaned at least every two months under normal use. Pivot dirt cup into vacuum body and press firmly until it locks into place. Press firmly to secure.Ĥ.5 Place bottom of dirt cup into vacuum body first. Place the vacuum in the upright position before removing the dirt cup.Ĥ.3 Press dirt cup release button (C) and pivot cup out.Ĥ.4 Hold dirt cup over trash receptacle, push dirt cup door release lever (D) to open dirt cup door (E). If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a service center prior to continuing use.Ĥ.2 To maintain optimal performance, empty the dirt cup before the dirt cup reaches the max line (B). Clean rinsable filter and/or filter made with HEPA mediaĪny other servicing should be done by an authorized service representative.Rinsable filter and/or filter made with HEPA media is dirty.MAINTENANCEįamiliarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure continued cleaning effectiveness.Ĥ.1 The System Check Indicator located at (A), alerts you to possible system performance issues.
Other cleaning tools may be washed in warm water with a detergent. To clean Hose and Turbo Tool, wipe with a damp cloth. When using tools, always ensure handle is in the upright position.ģ.5 To return cord for storage, hold plug and press down Cord Release Pedal (B) on side of cord reel. Do not place cleaner on stairs or furniture, as it may result in injury or damage. To avoid personal injury or damage, and to prevent the cleaner from falling, always place cleaner at bottom of stairs on floor. To lock back into place, push hose into hose tube until you hear a click.ģ.3 To attach tool or wand to hose, push firmly into place.ģ.4 Use the Hose and Turbo Tool (Tool varies per model) for stair cleaningĬAUTION Use extra care when cleaning on stairs. Use Adjustable Dusting Brush to clean upholstered furniture, draperies, mattresses, clothing, carpeted stairs, light fixtures, and fans with 5 cleaning positions.ģ.2 To remove hose for tool use, press the hose release button and pull hose end out. Turbo Tool may be used for upholstered furniture, draperies, mattresses, clothing, and carpeted stairs.ĭ. Crevice Tool may be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards.Ĭ. Wand is used to give extra length to your hose. The vacuum is ready for tool use when handle is in upright position.Ī. Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. To turn brushroll OFF for Suction Only Mode, step on pedal (A). The vacuum is shipped with the brushroll in the ON position. SUCTION ONLY MODE/ BRUSHROLL SHUT-OFF for bare floors and very high pile carpetĢ.3 For optimal cleaning performance on bare floors and carpet with pile deeper than 1”, brushroll should be turned off. For high pile carpet, use high carpet setting to ease pushing effort.
Hard floor setting: for use on hard floors only.
To turn vacuum OFF (O=OFF), push switch to OFF position.Ģ.3 Prior to using, grasp the end of the plug and pull to release the cord from the cord reel until red tape is reached.Ģ.4 To adjust height setting, PUSH DOWN and TURN knob (C) to desired height setting.įor maximum cleaning performance, the following carpet height settings are recommended: To turn vacuum ON (I=0N), push ON/OFF switch (A) to ON position. Dirt cup is secure when you hear a click. Insert the hose into hose tube until you hear a click.ġ.4 Place Crevice Tool into Wand and slide into tool storage area on left back side (C) of vacuum and place Turbo Tool on right back side (E) of vacuum as shown.ġ.5 Place adjustable dusting brush (F) on top of wand.ġ.6 Place bottom of dirt cup into vacuum body first. Using a Phillips screwdriver, fasten (1) large screw behind handle into vacuum base.ġ.3 Wrap hose around top of hose guide located on the handle. Make sure all parts are located before disposing of packing materials.ġ.2 Insert handle section into vacuum base. Remove all parts from carton and identify each item shown.
#Hoover whole house rewind repairs manual#
Hoover UH71250 WindTunnel 2 Whole House Rewind Corded Bagless Upright Vacuum Cleaner - Use Manual - Use Guide PDF.
0 kommentar(er)
